Instrukcja obsługi AXESS AXVI-1731

AXESS Niesklasyfikowane AXVI-1731

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AXESS AXVI-1731 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
AXVI-1731
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2024 METRA ELECTRONICS CORPORATION REV. 1/31/24 INSTAXVI-1731
ATTENTION: With the key out of the ignition,
disconnect the negative battery terminal before
installing this product. Ensure that all installation
connections, especially the air bag indicator lights, are
plugged in before reconnecting the battery or cycling
the ignition to test this product.
NOTE: Refer also to the instructions included with the
aftermarket accessory before installing this device.
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
Honda Civic LX Data Interface 2016-Up
APPLICATIONS
• Designed for Non-Amplified vehicles
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Pre-wired AXSWC harness included (AXSWC sold separately)
• Retains the factory backup camera
• Retains balance and fade
• Includes the AXCSD-6V 12-volt to 6-volt converter
• Micro-B USB updatable
HONDA
Civic LX 2016-Up .................................................
• AXVI-1731 interface
• AXVI-1731 harness
• AXCSD-6V 12-volt to 6-volt converter
Visit for more detailed information about the product
AxxessInterfaces.com
and up-to-date vehicle specific applications.
TABLE OF CONTENTS
Connections 2-3 ........................................................
Radio Feedback Legend & Diagram 3 ....................
Installing the AXVI-1731 4 .........................................
Initializing the AXVI-1731 4 .......................................
2
CONNECTIONS: LD-XSVI-1731-NAV HARNESS
Steering Wheel
Control (AXSWC)
(Sold Separately)
Front
Rear
Sub
AUX-IN
Rear View
SWC
(Your radio’s features may vary)
LD-XSVI-1731NAV
AXCSD-6V
Blue/White - Reverse trigger
Black - Chassis ground
Blue/Red - Camera power
*Accessory power can also be used if
the radio has the option to monitor
the camera while in motion.
*
Aftermarket Radio
12-Pin
Vehicle Connectors
Radio Connections
Interface
12-Pin
E1
E2
Black - Ground wire
Yellow - Battery wire
Red - Camera power 6V
Red - Accessory power
Green - Rear left speaker + output
Green/Black - Rear left - speaker output
Green/Purple - Reverse backup camera
Light Green - Parking brake
Orange - Illumination
Blue/Pink - VSS/Speed-Sense
Gray - Front right + speaker
Gray/Black - Front right - speaker
White - Front left + speaker
White/Black - Front left - speaker
Purple - Rear right + speaker output
Purple/Black - Rear right - output
After Interface Has Been Programmed: Notes For 2-Pin Connector (E to E1)
RESET , and let it program to vehicle and aftermarket radio. AXSWC
With all connections made, if you do not get correct controls for aftermarket
radio, go ahead and disconnect your to and connect to instead.2-Pin E E1 E E2
Reset and allow the to detect your aftermarket radio and controls. AXSWC
Make sure you get the following flashes and flashes (1st and 4th Green Red
Green Red longer followed by the correct number of flashes for aftermarket
radio being used. (Refer to on next page.)Radio LED Feedback Legend
3
REV. 1/31/24 INSTAXVI-1731
RADIO FEEDBACK LEGEND & DIAGRAM
12-pin pre-wired AXSWC harness:
This harness is to be used along with the
optional AXSWC (not included) to retain
steering wheel audio controls. If the AXSWC
is not being used, disregard this harness. If
it will be used, please refer to the AXSWC
instructions for radio connections and
programming.
Note:
Disregard the harness that comes with
the AXSWC.
Connect the wire to the accessory wire.Red
2-pin connector ( E TO E1):
RESET AXSWC, and let it program to vehicle
and aftermarket radio.
With all connections made, if you do not get
correct controls for aftermarket radio, go
ahead and disconnect your 2-pin to and E E1
connect toE E2 instead. (See diagram page 2)
Reset and allow the to detect your AXSWC
aftermarket radio and controls. Make sure
you get the following flashes and Green Red
flashes (1st and 4th longer followed Green
by the correct number of flashes for Red
aftermarket radio being used ( Refer to
Radio LED Feedback Legend at right.)
CONNECTIONS CONT.
L.E.D. Feedback: Red The (23)
L.E.D. flashes represent a different
radio manufacturer for the AXSWC
interface to detect. For example,
if you are installing a radio, JVC
the will flash AXSWC interface Red
(5) times, then stop. Following is
the , which L.E.D Feedback Legend
indicates the flash count of the radio
manufacturer
L.E.D FEEDBACK LEGEND
Flash Count
Radio
1
Eclipse (type 1) †
2Kenwood ‡
3Clarion (type 1) †
4Sony / Dual
5JVC
6Pioneer / Jensen
7Alpine *
8Visteon
9Valor
10 Clarion (type 2) †
11 Metra OE
12 Eclipse (type 2) †
13 LG
14 Parrot **
15 XITE
16 Philips
17 TBA
18 JBL
19 Insane
20 Magnadyne
21 Boss
22 Axxera
23 Axxerra (type 2)
KEYNOTES
* If the flashes (7) times, and AXSWC interface Red
an radio is not installed, that means there Alpine
is an open connection not accounted for. Verify
that the 3.5mm jack is connected to the correct
steering wheel jack/wire in the radio.
** The is required (sold separately). AXSWCH-PAR
Also, the software in the radio must be rev. 2.1.4
or higher.
† If a or radio is installed and the Clarion Eclipse
steering wheel controls do not function, change
the radio to or Clarion (type 2) Eclipse (type 2)
respectively. If the steering wheel controls still do
function, refer to the document Changing Radio Type
available at .
axxessinterfaces.com
‡ If a radio is installed and the L.E.D. Kenwood
feedback flashes (5) times instead of (2), manually
change the radio type to . To do this, refer Kenwood
to the Changing Radio Type document available at
axxessinterfaces.com.

Specyfikacje produktu

Marka: AXESS
Kategoria: Niesklasyfikowane
Model: AXVI-1731

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AXESS AXVI-1731, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane AXESS

AXESS

AXESS AXBUCS-MZ286V Instrukcja

9 Października 2024
AXESS

AXESS 99-7014HG Instrukcja

8 Października 2024
AXESS

AXESS AXGM-17 Instrukcja

8 Października 2024
AXESS

AXESS AXGMLN-34 Instrukcja

8 Października 2024
AXESS

AXESS 99-7382HG Instrukcja

8 Października 2024
AXESS

AXESS GMOS-12 Instrukcja

8 Października 2024
AXESS

AXESS XSVI-1788-NAV Instrukcja

8 Października 2024
AXESS

AXESS 99-7510HG Instrukcja

8 Października 2024
AXESS

AXESS AXBUCS-NI246V Instrukcja

8 Października 2024
AXESS

AXESS 99-3307G Instrukcja

8 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024