Instrukcja obsługi AXESS AXGM-044

AXESS Niesklasyfikowane AXGM-044

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AXESS AXGM-044 (16 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/16

AXGM-044

I N S T A L L A T I O N I N S T R U C T I O N S

Product Info

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS & INSTALLATION ACCESSORIES REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink • Tape • Wire cutter

• Zip ties • Small ﬂat-blade screwdriver

OPTIONAL ACCESSORIES

(sold separately)

AXSWC: Steering wheel control interface

ASWCSTALK: Steering wheel control add-on

TABLE OF CONTENTS

Connections .........................................................2-3

Installation .............................................................3

Programming .........................................................3

Adjustments ...........................................................4

Personalization Menu ............................................4

No OE Steering Wheel Controls ............................5

Chevrolet Cruze 2011-2015 / Cruze Limited 2016

(with monochrome screen)

• Provides accessory power (12-volt 10-amp)

• Retains R.A.P. (retained accessory power)

• Used in ampliﬁed or non-ampliﬁed systems

• Retains chimes

• Provides NAV outputs (parking brake, reverse, mute, speed sense)

• Prewired AXSWC harness (AXSWC sold separately)

• Retains OnStar/OE Bluetooth

• Adjustable volume for chimes and OnStar

• High level speaker input

• USB CAB cable updatable

• Retains balance and fade

• AXGM-044 interface

• AXGM-044 harness

• 16-pin harness with stripped leads

CONNECTIONS

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connect the wire to the accessory wire.Red

• Connect the Orange/White wire to the illumination wire. If the aftermarket radio doesn’t

have an illumination wire, tape off and disregard.

• If equipped with a factory ampliﬁer, connect the wire to the amp turn on wire.Blue/White

• Connect the wire to the left front positive speaker output.White

• Connect the wire to the left front negative speaker output.White/Black

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the Brown wire to the mute wire. If the aftermarket radio doesn’t have a mute wire,

tape off and disregard.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the wire to the VSS/speed sense wire.Blue/Pink

• Connect the wire to the reverse wire.Green/Purple

• Connect the wire to the parking brake wire.Light Green

From the AXGM-044 harness to the aftermarket radio:

• Connect the wire with a ring terminal to the radio chassis with the ISO screw supplied Black

with radio.

This wire must be connected as instructed otherwise the interface will not function.Note:

• The Black/Yellow wire will be discussed later in the section.Adjustments

• If the vehicle doesn’t come equipped with steering wheel controls, connect the Green/

Orange wire to the Green/Orange wire from the ASWCSTALK (sold separately) to retain the

personalization features. Refer to the section titled No OE Steering Wheel Controls for more

information and wiring for the ASWCSTALK.

• Connect the wire to the ground wire.Black

• Connect the Yellow wire to the battery wire.

• Connect the wire to the left rear positive speaker output. Green

• Connect the wire to the left rear negative speaker output.Green/Black

• Connect the wire to the right rear positive speaker output.Purple

• Connect the wire to the right rear negative speaker output..Purple/Black

• Connect the RCA jacks to the audio AUX-IN jacks (if applicable).

Note:

(a) This will allow you to retain the 3.5 AUX-IN jack in the console.

(b) The 3.5 jack can only be used if it is a single AUX-IN jack.

Continued on the next page

REV. 10/16/2019 INSTAXGM-044

12-pin pre-wired AXSWC harness:

• This harness is to be used along with the AXSWC (not included) to retain steering wheel

audio controls. If the AXSWC is not being used, disregard this harness. If it will be used, refer

to the AXSWC instructions for radio connections and programming. Disregard the harness

that comes with the AXSWC.

• Connect the wire to the accessory wire.Red

Note: The relay attached to the AXGM-044 is only for audible turn signal clicks. No extra steps are

required to retain this, so leave it as-is.

CONNECTIONS (CONT)

PROGRAMMING

INSTALLATION

With the key in the off position:

•

Connect the AXGM-044 harness into the interface, and then to the wiring harness in the vehicle.

Attention! If the interface loses power for any reason, the following steps will need to be

performed again.

• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.

If the radio doesn’t come on within 60 seconds, turn the key to the off position, Note:

disconnect the interface, check all connections, reconnect the interface, and then try again.

• Turn the key to the off position, and then to the accessory position. Test all functions of the

installation for proper operation, before reassembling the dash.

Specyfikacje produktu

Marka:	AXESS
Kategoria:	Niesklasyfikowane
Model:	AXGM-044

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AXESS AXGM-044, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane AXESS

AXESS AXBUCS-MZ286V Instrukcja

9 Października 2024

AXESS 99-7014HG Instrukcja

8 Października 2024

AXESS AXGM-17 Instrukcja

8 Października 2024

AXESS AXGMLN-34 Instrukcja

8 Października 2024

AXESS 99-7382HG Instrukcja

8 Października 2024

AXESS GMOS-12 Instrukcja

8 Października 2024

AXESS XSVI-1788-NAV Instrukcja

8 Października 2024

AXESS 99-7510HG Instrukcja

8 Października 2024

AXESS AXBUCS-NI246V Instrukcja

8 Października 2024

AXESS 99-3307G Instrukcja

8 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024