Instrukcja obsługi AKAI ABTS-1002

AKAI głośnik ABTS-1002

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AKAI ABTS-1002 (6 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/6
2
Please read the manual carefully and keep it for future reference.
The lightning ash with arrowhead symbol, within an equilateral Triangle, is intended to alert the user to the
presence of not insulated dangerous voltages within the product’s enclosure that may be of su cient
magnitude to cons tute risk of electric shock to persons. a
The exclam on point within an equilateral triangle is intended t alert the user t the presence of important o o
oper ng and maintenance (servicing) instruc ons in the literature accompanying the appliance.
CAUTION:
1. Do not place any recipients led with liquids, such as glasses or vases, on top of or directly next to fil
the app ance. They could fall over, causing water to enter the appli liance. Never pour out liquids
over the appliance. Do not place small objects, such as coins or paper clips, on the app ance since li
they could l inside the app ance and cause re or a fal li shock hazard! If any liquid or objects enter
the appliance, pull immediately the mains plug out of the socket and contact a spec list. ia
2. 0nly pull the mains plug out of the socket by the intended gripping surface. Do not pull it by the
cable.
3. Never plug the mains plug in or out with damp or wet hands
4. Electrical app ances must be kept out of the reach of children. Be parli cularly careful if children are
present. Children are not aware of the hazards involved in handing electrical app ances li
improperly. Children could a empt to poke objects into the appliance. There is a life-threatening
danger of electrocu on.
5. Never place the appliance on an unstable or mobile surface. Persons could be injured or the
appliance damaged by it falling down.
6. AII persons involved in opera ng, insta ing and servicing the appliance and pu ng it into service ll
must be trained and qua ed accordingly and observe these operali ng instru ons.
7. Defec ve mains cables may only be replaced by specialists. Danger of shock hazard!
8. If you are not sure about the correct connec on or if ques ons arise which are not answered by
the opera ng instruc ons, please do not hesitate to contact s port or a specialist of your choice. up
Consult a specialist if you are in doubt about the opera ng principle or the safety of the product.
9. Please plug the adaptor and switch the unit o if you don’t use it for a long un me, to avoid damage
due to voltage surges.
10. No naked ame sources such as lighted candles should be placed on the apparatus.
11. A warning that ba ries (ba ry pack or ba eries installed) shall not be exposed to excessive heat
such as sunshine, re or the like.
12. Where the MAINS plug or an appliance coupler is used as the disconne device, the disconnect ct
device shall remain readily operable.
Introduc on:
This speaker can be used with any audio output device such as personal computer, DVD, VCD, LD, TV, MP3,
FM radio, Bluetooth, etc.
3
Remote Control
1. Power on/o
2. Mute
3. Repeat key (single repeat, repeat all)
4. Mode key (Choose from AUX/USB/SD/BLUETOOTH/FM)
5. 0-9 keys
6. Sound mode key (Choose from rock, pop, jazz)
7. Record key (Press to start and again to stop recording)
8. Play/pause (the sound will be muted when paused)
9. Volume-
10. Volume+
11. Previous song
12. Next song
Use of the Remote Control
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance.
Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn’t work properly, please check the ba eries.
Top Panel Descrip on
1. AUX INPUT (connect the supplied lead for FM recep on)
2. Main Volume control
3. TREBLE
4. BASS
5. ECHO
6. MIC.VOL
7. MIC. EQ
8.
9. U
STANDBY
SB /SD CARD INPUT
10.
P
FM ANTENNA
OWER SWITCH (POWER ON/OFF)
11. MODE (SWITCH TO USB/SD/
BLUETOOTH/AUX-IN)
12. PLAY (PLAY/PAUSE MUSIC)
13. NEXT (NEXT SONG)
14. PREV (PREVIOUS SONG)
15. LED ON/OFF (TURN ON/OFF LED)
16.
17.
18. CHARGING INPUT JACK (AC INPUT):
Charging led is on during charging process
MIC INPUT (TO INSERT WIRED MIC)
Wireless Microphone
1. Open ba ery cover and insert a ba ery according to the + and – markings inside the compartment.
2. Turn on the microphone. If the power indicator doesn’t ash nor lights up steadily check if the
ba ery is charged and if it has been inserted with the correct polarity.
3. Adjust the volume of the wireless microphone when you sing.
4. If the power indicator ashes when you switch on the wireless microphone, the baery is low and


Specyfikacje produktu

Marka: AKAI
Kategoria: głośnik
Model: ABTS-1002

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AKAI ABTS-1002, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje głośnik AKAI

AKAI

AKAI ACS-506 Instrukcja

4 Stycznia 2025
AKAI

AKAI ACS-696 Instrukcja

3 Stycznia 2025
AKAI

AKAI ACS-656 Instrukcja

3 Stycznia 2025
AKAI

AKAI TB340-47 Instrukcja

2 Października 2024
AKAI

AKAI ASB12 Instrukcja

2 Października 2024
AKAI

AKAI SS048A-616 Instrukcja

12 Września 2024
AKAI

AKAI ABTS-112 Instrukcja

12 Września 2024
AKAI

AKAI HT 993 Instrukcja

5 Września 2024
AKAI

AKAI DJ-4308A Instrukcja

1 Września 2024
AKAI

AKAI DJ-3210 Instrukcja

1 Września 2024

Instrukcje głośnik

Najnowsze instrukcje dla głośnik